The APT‐1400F is a next‐generation flying probe test system which has unprecedented performance in terms of test speed, positioning accuracy and test coverage. Removing the requirement for a conventional bed‐of‐nails fixture and providing a wide variety of test facility will contribute largely to your R&D department and NPI section that ought to validate low‐volume productions.
In addition to the four standard moving probes which are installed diagonally to the board under test, the APT‐1400F is designed to use anther two Z mechanisms (option) which can be installed by either moving probe or IC‐open test probe that moves up and down vertically. The vertical Z axis units enable access to the test points which are hard for the standard moving probes to access, while also enabling contact to the location at different heights with accuracy.

The TAKAYA APT-1400F is the fastest flying probe test system in the world and sets new standards in speed and test coverage for the competition.  
The system has been specially developed for the test of complex circuit boards and large quantities. The APT-1400F has 6 flying probes, of which 2 are vertical probes that enable accesses to contact points that could not previously be reached.  
The APT-1400F does not make any compromises between speed, reliability and long service life. The design of the XY table has been completely revised and optimally adapted to the high travel speed of the test probes and to the new mechanical design of the axes. An outstanding measurement unit and numerous innovative test algorithms enable significant increase of the test coverage on your circuit boards.  
Breakthrough 4-heads & 6 flying probes system
High power motors and new high speed controllers
50% faster than conventional Flying Probe Tester
25% more accurate, smallest pad size < 60µm
New design of the XY axis and the XY table made of granite
Flexible “Composite Robot” longlife measurement and control cable
Advanced soft touch control
Measuring circuits mounted on the flying heads
Newly developed flexible board clamping mechanism
Conveyer system with an automatic width adjustment and SMEMA interface
n-Line Application: All APT systems are of course also available as In-Line variant. Equipped with a transport system with automatic width adjustment, the flying probe testers can be used for completely automated operation in a production line or in magazine to magazine operation